MIL-DTL-62069G(AT)
3.8 Marking. The control and flasher units shall both be marked in accordance with
SAE AS478 and each shall include as a minimum the following:
a.
24 Vdc
Manufacturer s identification
b.
Manufacturer s part number (P/N)
c.
d.
Serial number
e.
Military part number
f.
Federal stock number
g.
US
3.9 Workmanship. Workmanship shall be of a quality which will assure a product free
of burrs, rust, scratches, chips, sharp edges, loose or defective connectors, cracked insulation,
faulty soldering or other defects which affect serviceability or appearance.
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are
classified as follows:
a. First article inspection (see 4.2).
b. Conformance inspection (see 4.3).
4.2 First article inspection. The first article sample (see 3.1) shall consist of four
specimens each of the control and flasher unit. They shall be properly identified as
representative of the units proposed to be delivered to the Government. First article sampling
and testing is the responsibility of the manufacturer unless modified by the contract (see 6.2).
Government surveillance of testing to assure examination for defects specified in 4.3.2 and
testing as specified in table I is required.
4.2.1 Order of inspection. Inspection shall be in the order listed in table II and table III.
4.2.1 Failure. Failure of any first article specimen to pass any specified examination or
test may be cause, at the option of the Government, for refusal to conduct additional testing until
the faults revealed by the tests have been corrected.
4.3 Conformance inspection.
4.3.1 Sampling. Sampling shall be as specified in the contract (see 6.2).
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business