INCH-POUND
MIL-DTL-62069G(AT)
09 June 2010
SUPERSEDING
MIL-DTL-62069F(AT)
31 August 1998
DETAIL SPECIFICATION
CONTROL, DIRECTIONAL SIGNAL LIGHT, AUTOMOTIVE:
24 VOLT DC, SOLID STATE
This specification is approved for use by the U.S. Army Tank-automotive and
Armaments Command, Department of the Army, and is available for use by all
Departments and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers control and flasher units of the solid state type used
on military vehicles.
1.2 Classification. For the purpose of this specification, components are classified as
follows (see 6.2):
Unit 1
-
Control Unit
Unit 2
-
Flasher Unit
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents in other sections of this specification or
recommended for additional information or as examples. While every effort has been made to
ensure the completeness of this list, document users are cautioned that they must meet all
specified requirement documents cited in sections 3 and 4 of this specification, whether or not
they are listed.
2.2 Government documents.
Comments, suggestions, or questions on this document should be addressed to
U.S. Army RDECOM, Tank Automotive Research, Development and Engineering Center,
ATTN: RDTA-EN/STND/TRANS MS #268, 6501 E. 11 Mile Road, Warren, MI 48397-5000
or emailed to DAMI_STANDARDIZATION@conus.army.mil. Since contact information can
change, you may want to verify the currency of this address information using the ASSIST
Online database at https://assist.daps.dla.mill/online/.
AMSC N/A
FSC 2590
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business