A-A-52502B
2.3 Identification markings. Identification markings shall be permanent and legible and shall include, as a minimum, the manufacturer’s identification code (CAGE), the contract number, and the part or identifying number (PIN) (see 6.1).
3. REGULATORY REQUIREMENTS
3.1 Recovered material. Recycled, recovered, or environmentally preferable materials should be used to the maximum extent possible provided that the material meets or exceeds the operational and maintenance requirements, and promotes economically advantageous life cycle costs. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR).
4. PRODUCT CONFORMANCE PROVISIONS
4.1 Responsibility for inspection. The contractor is responsible for the performance of all inspections (examinations and tests).
4.2 Product conformance. The products shall meet the salient characteristics of this CID, conform to the producer’s own drawings, specifications, standards, and quality assurance practices, and be the same product offered for sale in the commercial market. The Government reserves the right to require proof of such conformance.
5. PACKAGING
Preservation, packaging, packing, labeling, and marking for the desired level shall be as specified in the contract (see 6.3).
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
6.1 Part or identifying number (PIN). The following part identification numbering system is for Government purposes and does not constitute a requirement for the contractor. The PINs to be used for the valve assembly acquired to this CID are created as follows:
AA 52502 - X
AA = CID designator
52502 = CID number
X = 1 - Valve assembly 4 - Knob
2 - Seat 5 - Spring
3 - Valve
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business