MIL-DTL-82001F
2.3 Non-Government publications. The following documents form a part of this document to the extent
specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
AEROSPACE INDUSTRIES ASSOCIATION (AIA)
NAS 3417
- Packaging of Electrical Cable-Cord-Wire
(Copies of these documents are available online at https://www.aia-aerospace.org or from the Aerospace
Industries Association, 1000 Wilson Boulevard, Suite 1700, Arlington, VA 22209-3901.)
SAE INTERNATIONAL
SAE J560 Seven-Conductor Electrical Connector for Truck-Tractor Jumper Cable.
SAE J561 Electrical Terminals-Eyelet and Spade Type.
SAE J1067 Seven Conductor Jacketed Cable for Truck Trailer Connections.
(Copies of these documents are available on line at www.sae.org from SAE International, 400
Commonwealth Drive, Warrendale, PA 15096-0001, and Tel: 877-606-7323 [inside USA and Canada] or
724-776-4970 [outside USA], email at CustomerService@sae.org.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict
between the text of this document and the references cited herein, the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
3. REQUIREMENTS
3.1 Description. The cable assembly shall consist of a 7-contact cable connector cable conforming to
SAE J1067, a voltage control unit, not less than 2 feet of 7-conductor cable conforming to SAE J1067,
and a 12-contact cable connector plug conforming to MS75020. The voltage control unit shall provide the
required reduction of voltage from a 24V tractor system for 24V or 12V trailer operation.
3.2 First article. When specified (see 6.2), the contractor shall furnish a cable assembly for first article
3.3 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible, provided that the
material meets or exceeds the operational and maintenance requirements, and promotes economically
advantageous life cycle costs.
3.4 Construction. The cable assembly shall be constructed so that a straight pull of not less than 75
pound-force (334 N) between the jumper cable and each cable connector plug or the voltage control
enclosure shall be resisted without damage to the components. Cable terminations, at cable connector
plugs and at the voltage control unit, shall incorporate a strain relief which relieves all tension from the
individual electrical connections. Conductor insulation shall be protected against abrasion, due to
vibration or as a result of applied tension, at points of contact with conducting material.
3.4.1 Cable. Jumper cable shall conform to SAE J1067.
3.4.2 Cable terminations. The 7-contact cable connector plug shall conform to SAE J560. The 12-
contact cable connector plug shall be the pin type conforming to MS75020, Part or Identifying Number
(PIN) MS75020-1. Conductor terminals, within the control box, shall conform to SAE J561 with the type
to be determined by the manufacturer.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business